Divanti Group generates large volume of iCORE and Core 2 Duo Laptops monthly. Each lot is separated by either iCORE Laptops or Dual Core/Core 2 Duo Laptops. Our approximate order ranges from 100-300 units on average. If you are interested in purchasing laptops in bulk, feel free to send me your email address and I can send over current stock lists that is available.
With the adequate production capacity and total quality management,a wide variety of CWDM SFP transceivers and CWDM xfp transceivers are available with different rates (1.25G and 2.5G ) and transmission distance(from 40km to 120km). Details about one modle of ATOP's CWDM SFP transceiver here.
Product features
Up to 1.25Gb/s bi-directional data links
Hot-pluggable SFP footprint
Uncooled DFB laser transmitter in 8 possible CWDM wavelengths
Duplex LC connector
RoHS compliant and Lead Free
Up to 80 km on 9/125
Metal enclosure for lower EMI
Single 3.3V power supply
Low power dissipation <600mW
Commercial operating temperature range: 0centigrade to 70 centigrade
General
ATOP's AP-SCxx125-3CxLxx CWDM Small Form Factor Pluggable (SFP) transceivers are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA). They simultaneously comply with Gigabit Ethernet as specified in IEEE STD 802.3 and 1x Fibre Channel as defined in FC-PI-2 Rev. 10.0 .They are RoHS compliant and lead-free.
Compliant with iec 60825-1 class 1/cdrhclass i laser eye safe
Rohs compliant products available
Applications:
Switch to switch interface
Switched backplane applications
Router/server interface
Other optical transmission systems
Description:
Atop ag-5524-bz8 transceiver is a high performance, cost effective module supporting dual data-rate of 1.25gbps/1.0625gbps and 80km transmission distance on smf. It is fully compatible with gigabit interface converter (gbic) specification (sff-8053), rev5.5. It can be inserted in or removed from host chassis without shutting power of the host system. It uses 1550 nm dfb laser for lr-2 applications, cwdm is also available.
Standards:
Compatible with gbic specification (sff-8053), rev 5.5
Compatible with ieee 802.3z
Compatible with ansi specifications for fibre channel
Compatible with fda 21 cfr 1040.10 and 1040.11, class
100% CISCO CWDM-SFP10G-1470 COMPATIBLE SFP TRANSCEIVER:Compatible for Cisco CWDM-SFP10G-1470, wavelength: 1470nm, the transmission distance up to 40km.
TECHNICAL SPECS: 10Gb/s data rate, duplex LC connector, cable type: SMF, working temperature: -5 ~ +70, Tx Power(dBm): -2 ~ 4, Rx Sens.(dBm): -15.8.
EASY TO USE : Plug and play, hot-pluggable. Rotate the ring latch down at 90 degree angle to unlock, then pulling transceiver out from switch. Always keep the protective dust plug on the SFPâ??s optical bores until you are ready to make a connection. MiniGBIC module with DDM allows you to monitor the critical information, to find out some potential problems.
PREMIUM QUALITY: All of products are manufactured under strict quality control system, every module has been tested one by one on different switches before shipping, to ensure the compatibility. Hot-swappable in Cisco routers and switches
OUTSTANDING SUPPORT: Backed by QSFPTEK Store for the life of the module itself, not your equipment; our modules won't void your switchs, with access to our tech support
Description
The SFP transceiver is high performance, cost effective module supporting dual data-rate of 1.25Gbps/1.0625Gbps and from 10km to 20km transmission distance with SMF.
The transceiver consists of two sections: The transmitter section incorporates a FP laser. And the receiver section consists of a PIN photodiode integrated with a trans-impedance preamplifier (TIA). All modules satisfy class I laser safety requirements.
The optical output can be disabled by a TTL logic high-level input of Tx Disable. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver.
The standard serial ID information compatible with SFP MSA describes the transceiver¡¯s capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the 2-wire serial CMOS EEPROM
protocol. For further information, please refer to SFP Multi-Source Agreement (MSA).
The SFP transceivers are compatible with RoHS.
1490nm cwdm dfb laser and pin photodetector for 80km transmission
Compliant with sfp msa and cwdm-sfp-1490 with duplex lc receptacle
Digital diagnostic monitoring:
Internal calibration or external calibration
Compatible with rohs
+3.3v single power supply
Operating case temperature:
Standard : 0 to +70+¼pc
Industrial : -40 to +85+¼pc
Applications
Gigabit ethernet
Fiber channel
Switch to switch interface
Switched backplane applications
Outer/server interface
Other optical transmission systems
Description
The sfp transceivers are high performance, cost effective modules supporting dual data-rate of 1.25gbps and 80km transmission distance with smf.
The transceiver consists of three sections: a cwdm dfb laser transmitter, a pin photodiode integrated with a trans-impedance preamplifier (tia) and mcu control unit. All modules satisfy class i laser safety requirements.
The transceivers are compatible with sfp single-source agreement (msa) .
The perfect pillowcase for birthdays, anniversaries or even to say "I love you" without words.
Choose from a variety of designs and create your own unique pillow! Personalize it with names, messages or your favorite photos to embody your feelings.
Each pillow is made with care to ensure that your personal touch is visible and unique.
Unique Quality: Our cushions are made of top quality materials, durable and pleasant to the touch. Among them you will also find fillings that offer soft support,
ideal to decorate your home or to be used as practical and comfortable accessories. Every touch counts, because we believe that quality is as important as appearance
High quality prints: Every detail is printed with love, with vibrant colors and in the highest resolution.
