Find Verified Electric Transformers Suppliers, Manufacturers and Wholesalers

From 25KVA to 5000KVA power and from 6,3 KV to 36 KV voltage features, Trans-el produces Oil type, hermetic transformers or transformers with an oil expansion tank, Indoor and outdoor power and distribution Transformers.

From 25KVA to 5000KVA power and from 6,3 KV to 36 KV voltage features, Trans-el produces Oil type, hermetic transformers or transformers with an oil expansion tank, Indoor and outdoor power and distribution Transformers

Gas ignition transformers from 2 outlets to 6 outlets. For gas cookers, gas ovens. Potted with epoxy resin.

Neon Lamp Transformers from 6KV up to 12KV. Potted under vacuum with epoxy resin.
Protections: Output open circuit, overload, output short circuit, earth-leakage, input over voltage.

GANZ current transformers meet the highest international quality standards with more than 50 years of experience in
industry.

Wise - transformer

Wise trnsformers are built according to all ce rules , are ferro-magnetic built , balast type , is a classe i product .

20 units pack , eacch transformer 0, 800gr , palets of 1500 transformers

250 kVA OIL TYPE DISTRIBUTION TRANSFORMER
Measuring winding resistances

Measurinq rotation ratios

Inspecting polarity or connection group

Measuring short circuit and load losses

Measuring idle losses and current

Induced voltage test

Applied voltage test

Measuring insulation resistances

Transformers, for which mounting, drying

and oil filling works are completed, are

subjected to below mentioned routine and

typical tests as specified by TS 267 standard.

Oil breakdown stress control

Loss gap (tq) measurement (DOUBLE test)

Measuring painting thickness

Temperature increase (heating test)

Measuring of audible noise level

Boiler lifetime test (For Hermetic Transformers)

Mechanical strength test against short circuits

This test is conducted in CESI/ITALIA,

IPH/GERMANY test laboratories.)

Except for the mechanical strength test against

short circuits, all typical tests are conducted

in the laboratories of our company,

Used transformers

Used transformers

Toroidal magnetic cores are made of a Fe-based thin (20 microns) nanocrystalline ribbon and have low loss, high induction of saturation, high operating temperature (up to 150 C), high magnetic permeability. Magnetic cores have a negative temperature coefficient of losses that provides stabilization mode transformer temperature.
Application in power high- frequency transformers push-pull,bicyclic SMPS, DC-DC converters, audiotransformers.
High permeability provides good electromagnetic connection of windings and low leakage inductance values.
HIGHLIGHTS OF THE MATERIAL:
Induction amplitude, Bm (25 C) 1,2 T
Induction amplitude, Bm (90 C) 1,1 T
Curie temperature, Tc 570 C
Magnetostriction less than 0,5 x10 ^ -6
Magnetic Permeability (100 kHz) - up to 20,000

Co-based amorphous core in plastic container
1. high permeability
2.Thickness (1820 mkm)
3. Annealing in transverse field, permeability more than 100000, very low loss, flat hysteresis loop
4. Common-mode filter chokes, current transformers, including for precise electronic electricity meters, protective cutout, High Frequency power transformers in SMPS, audio transformers, etc.
5.D from 4-32mm
Ribbon wound magnetic core is placed into hard protective container of glass-polyamide and mechanically fixed with silicone sealant.
Co-based amorphous ribbon wound magnetic core is placed into hard protective container of glass-polyamide and mechanically fixed with silicone sealant.Size veries:outer D =4-32mm.The container has rounded edges and is designed for direct winding of a thick wire. The container provides reliable mechanical protection and preservation of amorphous material's properties. All materials comply with UL94V-1 / 0.
1. High permeability
2.Thickness (1820 mkm)
3. Annealing in transverse field, permeability more than 100000, very low loss, flat hysteresis loop
4. KEY FEATURES OF THE AMORPHOUS MATERIAL:
Induction amplitude, Bm (25C) 0.59 T
Induction amplitude, Bm (90C) 0.50 T
Curie temperature, Tc 220C
Operating temperature range -60C ... 100C
Magnetostriction less than 0.110^-6
Typical permeability (10 kHz) - 120 000
Typical permeability (100 kHz) - 35 000

Co-based amorphous core in plastic container
1. high permeability
2.Thickness (18-20 mkm)
3. Annealing in transverse field, permeability more than 100000, very low loss, flat hysteresis loop
4. Application: Common-mode filter chokes, current transformers, including for precise electronic electricity meters, protective cutout, High Frequency power transformers in SMPS, audio transformers, etc.

KEY FEATURES OF THE AMORPHOUS MATERIAL:
Induction amplitude, Bm(25C) 0.62 T

Induction amplitude, Bm(90C) 0.54 T

Squareness ratio Br/Bm (@ 100 kHz, 80 A/m) at least 0.90

Curie temperature, Tc 225C

Operating temperature range -60C ... +100C

Magnetostriction less than 0.110^-6

Dry-type transformer.Power range is:100-20000-30000 kVA.
Durable to instantenous temperature changes and also to short-circuit.
100% protected from moisture.It cant get fired has an ability to extinguish the fire.
Does not contain any Halogen or Nitrogen.Price changes due to power range.

We are the Zhejiang Shuangpeng electric Co.Ltd.

We have national high and new tech enterprise,AAA credit rating enterprise,technology oriented small and medium-sized enterprises.

In the system certificate,we have many power transformer qualification and dry-type transformer qualification.

We export transformers to Southeast Asia, Africa and all regions of the world. Please give us a chance to quote, and we will not disappoint you.

We sell current transformers. Please contact me for quotation.