Impeller sand washing machine High-efficient Sand Washing Machine Industrial Sand Washing Equipment factory
The Dingbo XSD Series High-efficient Sand Washing Machine is an equipment to wash sand in coordination with the sand making machine., which is used for washing away the stone powder and impurity in the sand made by the Sand Making Machine, to increase the sand quality.
Sand Washing Equipment Working Principle
The electric motor runs slowly with the impellor after decelerated by the belt, decelerator and gears wheel. The sand and stone flow into washing launder from feeding launder, rolls with the impellor, and grinds each other. The impurity covering the sand is washing away. At the same time, add more water, the strong water flow will take away waste and some low-weight wastes from washing launder. Through the above process, the washing function is finished. The clean sand and stone is lift up by vane. When it goes up slowly, the water begins to drop through the mesh and fall back in the washing launder. On one hand, water is removed from the sand and stone; on the other hand, the water can be fully used. Finally, the sand and stone goes to the out launder from the rotary impellor to finish the washing task.
This machine is widely used in washing, grading and dehydrating quartz sand in Sand stone factories, Construction site, Glass Factory and so on.
Industrial Sand Washing Equipment Featuresï¼?
1. The machine is with high efficiency, reasonable structure, high capacity, low consumption and easy maintenance.
2. Drive Bearing device is separated from water and materials, which is greatly to avoid the bearing damaged due to soaking, touching sand and other pollutants.
3. Compared with the spiral sand washing machine, the loss of medium and fine sand as well as powder is minimal, so the grade and fineness modulus of washed building sand can meet the required standard.
This model is mainly used for balancing rotating work pieces, Such as large and medium- sized motor rotors, blowers, pump impellers, centrifugal, drying cylinders, and rollers, mine ventilator etc. The gimbals -driving offers several rotational speeds, large driving power, high precision and easy operation etc.
Specification Parameter:
Mass scope of workpiece(kg) 2000
Mass diameter of workpiece(mm) 1800
The distance between two bearing pedestals(mm) Min100
Journal diameter on roller carriages(mm) 40-240
Distance from coupling flange of drive shaft to center of farthest bearing (mm) 1800
Spindle speed(r/min) 280/560/900/1800
Motor Power(kw) 7.5(variable-frequency)
Universal coupling torque(N.m) 300
Minimum achievable Residual Unbalance(emar) 1g.mm/kg.
Supplier: Bushings, Valves, Impeller, Propeller, Gear Blanks And Pump Casings In Non Ferrous And Ferrous Alloys Buyer: Non Ferrous And Ferrous Components
The impeller feeder is a new type of excellent feeding equipment, mainly used in grain and oil, food processing and feed production line plants. This machine adopts a falling hammer crusher to make the feeding more even, which can prevent the motor from being overstressed due to too much feeding, causing high heat burnout.
This is a de-ironing device, installed near the discharge port to ensure that the machine provides clean material.
Features
The feeding speed is automatically adjusted by a frequency converter continuously, enabling the hammer mill to work constantly with a full load, so as to reduce power consumption;
A magnetic separating device is equipped near the material outlet, to guarantee that the clean material stream is provided for the hammer mill;
Both sides of the housing are sealed with end covers, so as to prolong the service life of bearings with pedestals;
The material inlet is set aside to reduce the possibility of material jamming between the vane and the inner wall of the box body;
The more you can click here.
