1) Constant Current Selected automatically depending on
ground conditions
Max. Current 500mA
Min. Current 1mA
2) Voltage (Max) 500 V (1000 Vpp)
3) Power 40W
b. Amplifier
Voltage Measurement
Input Impedance 10 M Ohm
Input Range 0-200V
Precision + 0.05 mV
Noise Rejection 95 dB at 50-60 Hz
c. Resistance Measurement
Apparent R Range m Ohm, Ohm, K Ohm
Apparent R Precision 0.02 m Ohm at 500 mA
d. System Data
Cycle time 12 seconds
Accuracy 2%
Diagnostic display 9 codes
Temp. Range 0 v 50 degree c
e. Power Source 12 Volt, 12 Ah Rechargeable Battery
Measuring capacity 2000 readings at 20 mA
200 readings at 500 mA
f. Weight 12.5 Kg
g. Dimensions L 400mm X W 225mm X H 330mm
Weight 20 kg of instrument Additional Accessaries 60-80 Kg.
Supplier: Gas lighter, led screen protector ( not even in domestic ), refill paper cups, table runner, earing brass clamp, auto brass electric parts, cashew nuts, wire mesh, petha sweet, niwar, mohini powder, vermicompost, dry bath incubator, test tube plastic, sordium citrate tube, health care product, ornamental freshwater fish, safed musli, used polymer bag, cotton linter, auto hood cover,
areca plate, rice
Weight Measurement Function: By Hours, minutes and seconds unit, Display the status of the usage of liquid gas and it can be used being installed on storage tank or tank lorry and can be carried as a portable measuring instrument.
PC Monitoring Function: As the remained liquid goes below 10% of its capacity, it automatically alarms to supplement liquid gas. Thus, the appropriate time for supplement of liquid gas can be decided on time.
Alarm Function: the liquid remaining of the storage tank is less than 10%, The alarm sound provides information that you can setting the a liquid supply time.
Diversity Of Power Supply: Use the usual 220volt electric, in case of power outage, the built-in battery will supply the charged electricity, in addition built-in battery is operated and available for tank lorry using the car battery.
Option (Printer : additional purchase): Receipt Output Function; Portable thermal transfer printer can use the output value measuring of storage tank and tank lorry without visiting a long measuring place directly by the output as a receipt.
1.General
PZ96 Series power analyzer specializes in measuring the data of all kinds of AC networks, such as the currents, the voltages, the powers, the energies etc... It may be used for local display, or it is connected with the control equipment in measuring and controlling system.
They are a kind of programmable analyzer. With the 4 key on the front, we can set their parameters according to the network which we measure. They have many option functions. They can be equipped RS-485 communication with Modbus-RTU protocol; or they can output analog signal. With logic input or logic output, we can realize controlling other equipment remotely
They are a kind of analyzer with excellent cost performance, since they regroup the functions of traditional electric transmitter and digital meters. Therefore they are widely being used in kinds of control system, SCADA system and power management system.
3.Options
- Display (L): LED or LCD display, the brightness can be set
- Communication (/C): RS485 (Modbus-RTU); 1 start bit, 8 data bit, 1 stop bit, no parity, speed
(1200/2400/4800/9600/19200)
- Alarm output(/J): 1 passive relay (1A/30VDC, 1A/250VAC); alarms of over voltage, low voltage and over current;
The hysteresis and the delay can be set
- Analog output(/M): DC4~20mA, DC0~20mA( load < 600ª+), DC0~5V,DC1~5V( load > 1kª+); Number: /M, /M3 (1 or 3
analog outputs)
- Logic options(/K)
4 logic inputs and 2 logic outputs
Logic Input: dry contact Input, supplied inside, optoisolator
Logic output: NO-NC contact; 1A/30VDC,5A/250VAC ( to control other equipments)
- Accuracy: 0.2
Note: /M and /K can not be chosen simultanously.
4. Specification
96 * 96 mm
PZ96-E3 3 Phase LED
PZ96L-E3 3 Phase LCD
72 * 72 mm
PZ72-E Single Phase LED
PZ72L-E Single Phase LCD
80 * 80 mm
PZ80-E Single Phase LED
PZ80-E3 3 Phase LED
PZ80L-E Single Phase LED
PZ80L-E3 3 Phase LCD
120 * 120 mm
PZ42-E3 3 Phase LED
PZ42L-E3 3 Phase LCD
