Model Suntrio Plus 25K
Input Parameters Input Parameters
Maximum DC power w 30300
Maximum DC input voltage v 1000
Mppt voltage range v 180900
Rated input voltage v 600
Starting voltage v 200
Minimum input voltage v 180
Maximum input current pv1 pv2 pv3 a 222222
MPPTNumber of tracks 3
Number of component strings MPPT per lane 02022002
Dc switch Built in
Output Parameters Output Parameters
Rated output power w 25000
Maximum output power va 27500
Rated AC voltage range 3LNPE220380V180V280V312V485V
Rated grid frequency 50Hz45Hz55Hz
Power factorcos 08 lead 08 lag
Number of output phases 3LNPE
Efficiency Efficiency
Maximum efficiency 9860
European efficiency600Vdc 9840
MPPT efficiency 995
Protections Protections
Overvoltage protection Built in
Insulation impedance monitoring of DC terminal Built in
Dc component detection Built in
Ground fault current monitoring Built in
Grid monitoring Built in
Ac output short circuit protection Built in
Low voltage crossing Built in
Overheat protection Built in
Ac surge protection Class iii protection class ii protection optional
Anti component attenuation module Optional
Dc surge protection Level ii protection optional
Dc fuse Optional
Cluster current detection Built in
Islanding protection monitoring AFD
Interface Interface
DC Jack MC4H4
AC Terminal Terminal block
LCDLED display 35 inch LCD Backlight
Display language english
communication interface 2RS4851RS232
communication method WiFiGPRSEthernet optional
General Parameters General Parameters
Isolation type Non isolated
Night wear w
Model Sununo Plus 2K
Input Parameters Input Parameters
Maximum DC power w 2400
Maximum DC input voltage v 500
Mppt voltage range v 60450
Rated input voltage v 360
Starting voltage v 70
Minimum input voltage v 50
Maximum input current a 11
Mppt track path 1
Number of component strings MPPT per lane 1
Dc switch Built in
Output Parameters Output Parameters
Rated output power w 2000
Maximum output power w 2200
Rated output current a 91
Maximum output current a 106
Rated AC voltage range v 220180280
Rated grid frequency range Hz 504555
Power factor cos 099 Full load
Total harmonic distortion thdi at rated power 995
Protections Protections
Overvoltage protection Integrated
Insulation impedance monitoring of DC terminal Integrated
Dc component detection Integrated
Ground fault current monitoring Integrated
Grid monitoring Integrated
Ac output short circuit protection Integrated
Ac ground detection Integrated
Ac lightning protection Integrated
Overheat protection Integrated
Islanding protection monitoring AFD
Interface Interface
Ac side connector quick connector
Dc side connector MC4H4
LCDLEDdisplay LCD 16x2Character backlight LED 3lamp
Display language english
communication interface RS232
communication method Wi fi GPRS Ethernet optional
General Parameters General Parameters
Isolation type Non isolated
Night wear w
Model Suntrio Plus 60K
Input Parameters Input Parameters
Maximum DC power [ w ] 72000
Maximum DC input voltage ( v ) 1000
Mppt voltage range ( v ) 280-900
Rated input voltage ( v ) 600
Starting voltage ( v ) 300
Minimum input voltage ( v ) 250
Maximum input current pv1 / pv2 / pv3 ( a ) 40/40/40
MPPTNumber of tracks 3
Number of component strings ( MPPT per lane ) 04-04-2004
Dc switch Built - in
Output Parameters Output Parameters
Rated output power ( w ) 60000
Maximum output power ( va ) 60000
Rated AC voltage / range 3L/N/PE,220/380V;180V~280V/312V-485V
Rated grid frequency 50Hz/45Hz-55Hz
Power factor(cos ) 0.8 lead ~ 0.8 lag
Number of output phases 3L+N+PE
Efficiency Efficiency
Maximum efficiency 98.90%
European efficiency[@600Vdc] 98.60%
MPPT efficiency>99.5%
Protections Protections
Overvoltage protection Built - in
Insulation impedance monitoring of DC terminalï¼? Built - in
Dc component detectio Built - in
Ground fault current monitoringï¼? Built - in
Grid monitoringï¼? Built - in
Ac output short circuit protectionï¼? Built - in
Low voltage crossingï¼? Built - in
Overheat protectionï¼? Built - in
Ac surge protectionï¼? Class iii protection, class ii protection ( optional )
Anti - component attenuation moduleï¼? Optional
Dc surge protectionï¼? Level ii protection ( optional )
Dc fuseï¼? Optional
Cluster current detectionï¼? Built - in
Islanding protection monitoringï¼? AFD
Interface Interface
DC Jackï¼? MC4/H4
AC Terminalï¼? Terminal block
LCD/LED displayï¼? 3.5 inch LCD Backlight
Display languageï¼? english
communication interfaceï¼? 2*RS485+1*RS232
communication methodï¼? Wi-Fi/GPRS/Ethernet ( optional )
General Parameters General Parameters
Isolation typeï¼? Non - isolated
Night wear ( w )ï¼?
Thank you for contacting us. We can offer best quality Alfalfa Pellets. Further, this is a 100% Natural Product grown and cultivated in Gujarat State of India, the nutritional specifications are subject to vary as no additions of foreign matters are made to increase/control the nutritional specification of the same.
Available In : 8 x 25 mm
We produce widest range of Alfalfa Pellets for Animal Feeding Objective. We produce 8� mm Alfalfa Pellet and 10� mm Alfalfa Pellet for Animal Feed Forage Industry
Alfalfa Pelleting Process
Generally its grown during the period of November to April Months of the year in India and the cutting process begins from the 45th� day of the plantation.
The field cut green alfalfa is spread on the agriculture land for sun drying process (which is generally called sun curing process). This is the most important phase of administration, wherein during the sun curing process the alfalfa leaves and stem has to be dried in such a manner that the leaves should not turn yellow or loose green pigments.
After 7 days of meticulous administration, the green alfalfa is converted in to hay.
The hay is loaded in trucks and transported to production side, where the first stage is to sieve (clean) the entire hay, so minor or major dust articles are removed from the same.
After cleaning process the hard stem particles are removed through a mechanical machining process and the available residue is absolutely clean and dehydrated soft leaves and soft steam.
The dehydrated alfalfa particles (leaves & steam) are grinded to a finer particles size. The overall texture of hay is now converted to Powder Form.
The powdered alfalfa is then passed through 100 degree Celsius stream for about 8 minutes, which detoxifies the alfalfa from any toxic elements and also gets cooked at a very digestible ratio.
The highly cooked alfalfa meal is then pelleted through feed extrusion methodology, during the process of pelleting again the cooked meal reaches to an extremely high temperature of 123 Degree Celsius, due mechanical thrust of the extruder in its 22 ft long barrel
The extremely hot pellets are then cooled down to a room temperature level, enabling the moisture level below 12%.
The above process produces the most advance format of Alfalfa Hay Pellet in 8 x 25 mm� and 6 x 25 mm size absolutely hygienic for Animal and Poultry feeding Purpose
Facts of Indian Alfalfa
The pricing of the alfalfa hay / pellet is totally dependent of the physical hay recovery after sun curing process, which varies 10% to 15%, which means when 100 Kgs of green alfalfa is sun dried, the hay recovery varies between 10Kgs to 15 Kgs.
The recoveries are totally dependent on the environmental factor and the water content within the stems of the alfalfa.
Countries like Canada, Northern US, New Zealand and Northern European Countries donâ??t get direct sun light (rather they get inclined sun lig
Kiln Dried Firewood oak birch/ Firewood beech dry wood Birch ash oak firewood For Sale
Firewood is made of locally supplied timber. The wood species we use to make firewood are beech, Ash, Oak, Birch, Alder, Pine, and Fir. Each log can be cut into pieces of 25, 30 or 45 cm, split 4-6 times for 8-15 cm diameter and stacked into 1m�³, 1,8m�³, 2m�³ or 2,2m�³ boxes or bags of 9.5 L, 21 L, 30 L, 40 L or 60 Liters. It is sold in 3 levels of moisture: fresh (35-55%), air-dried (25-35%) or kiln-dried (<25%).
Our logs are derived from hardwood (broadleaf) and softwood (conifers) species. The firewood is free from any chemicals or contaminations.
We are trading with hard firewood on pallets. It can be either fresh or dry up to 20%. Available species: Ash, Beech, Birch, Oak .
Best quality kiln dried Alder firewood packed in 2m3 crates.
Kiln dried firewood
Our company is the manufacturer of firewood and other bio-energy products like wood pellets, briquettes, wood charcoal.
Kiln Dried Firewood for Sale, Oak and Beech Firewood Logs
- Hornbeam Firewood
- Fir Firewood
- Ash Firewood
- Alder Firewood
- Oak Firewood
- Birch Firewood
- Spruce Firewood
- Beech Firewood
- Dried Kiln Firewood
- Dried Robber wood
- Dried Eucalyptus wood.
Measures outside: 1.2 m * 0.8 m * 2.0 m.
Split length: 25-100 cm
width of the split: 8-16cm
Wood fire size: 25cm, 33 cm or 50 cm;
The thickness of wood is 5-15 cm.
Fire wood diameter 7 - 19 cm;
Moisture Content: < 20%
Ash Content (db): < 0.5%
Abrasion: 2.0%
Calorific Value: > 4500kcal/kg
Diameter: 5cm to 15cm
Length: 20cm to 50m
We are offering 6mm and 8mm Wood pellets DIN EN PLUS packed in 15kg plastic bags, big bags or bulk. Volume up to 3000t per month. We can offer the pellets delivered to your place or near port anywhere in
Europe or Middle East. Bases:Pine,Beech,Fir,Spruce Oak, Hard coniferous.
Excellent Wood Pellet Standard
Ash amount: 0.7% max
Moisture: 10% max
Diameter: 6 mm-8mm
Length: 10mm-50mm
Made from pure wood , no bark
Bright, uniform surface color
No horizontal or vertical cracks
Density: 650kg/m3 min
calorific value: 4100 to 4500 kcal/kg
Uniform size: quality in production
Clear in water cup test
Non Toxic Fumes
Zero Additive
Package: 15KG/PP woven bag or 20KG/PP woven bag or as per customers
choice with desired logo.
Class A1 Pine Wood Pellets 6mm DIN+ plus & ENplus A1/A2 ( BSL Approved Wood Pellets In 15kg bags )
We are offering 6mm and 8mm Wood pellets DIN EN PLUS packed in 15kg plastic bags, big bags or bulk. Volume up to 3000t per month. We can offer the pellets delivered to your place or near port anywhere in
Europe or Middle East. Bases:Pine,Beech,Fir,Spruce Oak, Hard coniferous.
Excellent Wood Pellet Standard
Ash amount: 0.7% max
Moisture: 10% max
Diameter: 6 mm-8mm
Length: 10mm-50mm
Made from pure wood , no bark
Bright, uniform surface color
No horizontal or vertical cracks
Density: 650kg/m3 min
calorific value: 4100 to 4500 kcal/kg
Uniform size: quality in production
Clear in water cup test
Non Toxic Fumes
Zero Additive
Package: 15KG/PP woven bag or 20KG/PP woven bag or as per customers
choice with desired logo.
Automobile diesel fuel (EN 590) Grade E (winter), recommended for use at ambient temperatures up to minus 15 C (limiting filterability temperature).
Diesel fuel EN 590 (EN 590) Grade E is obtained from petroleum refined products and is intended for use as automotive fuel for diesel engines of cars and trucks. Diesel fuel meets the requirements of the international standard EN 590/2000 and is characterized by a low content of sulfur, aromatic hydrocarbons and a high cetane number, which leads to an overall reduction in sulfur oxide emissions, a decrease in the amount of particulate matter in exhaust gases and the formation of deposits in the fuel system of cars and heavy vehicles, reducing exhaust smoke and is the key to good starting properties of the fuel during cold start of the engine.
The oil refining industry produces diesel fuel in accordance with GOST 305-82 of three grades:
L - summer, used at ambient temperatures above 0 C;
3 - winter, used at temperatures up to -20 C (in this case, winter diesel fuel should have a stagnation <-35 C and n <-25 C), or winter, used at temperatures up to -30 C, then the fuel must have a stasis <-45 C and n <-35 C);
- Arctic diesel fuel, the temperature of which is up to -50 C. The sulfur content in diesel fuel of grades L and Z does not exceed 0.2% for type I fuel and 0.5 for type II fuel, and grade A 0.4%
