It is a high quality enamel with a modified silicone resin base, which allows you to renew all surfaces normally exposed to high temperatures. Heat resistant up to 300 C-700 C (check the Technical data sheet). Application: parts of heaters, stoves, ovens, chimney flues, barbecues, fire screens, motorcycle mufflers, etc. don't expose in direct contact with flames. Important: to obtain an optimal and long lasting result it is necessary for the painted parts to be exposed even if only once, to a temperature of at least 180 ' C; any less will make the hardening and adhesion of the enamel only partial. Clean carefully the surface before application and shake vigorously the can. After use, it's advisable to spray for 2/3 seconds with the spray upside down, to avoid the block of the nozzle.
Theaoson paint remover is composed of aerosol can, aerosol valve, paint liquid and propellant. It is a stripping paint remover with high-efficiency technology formula. It removes paint quickly and thoroughly, has strong removal ability, and is easy to use. It has a good effect on a variety of difficult-to-remove paint films. It is easy to clean after removing paint and does not affect repainting. It is especially suitable for the removal of self-drying alkyd paint, amino baking paint, partial epoxy, partial light curing and high temperature curing two-component paint film.
Supplier: Environmental test chamber, salt spray chamber, dust test chamber, rain test chamber, altitude chamber, thermal shock chamber, industrial oven, industrial dryer, temperature forcing system
Ature:remove all oil or grease, soluble contaminants and other foreign matter
All surfaces to be coated should be clean, dry and free from contamination
If applied on rusty surface, rusty layer thickness should be below 50mm, other than bottom surface processing requirements, without acid and sandblasting processing, catalytic reaction, to get black protective layer and solvent (acrylic acid, polyurethane, epoxy resin, alkyd resin, amino paint or water-based paint) match well, will not occur and paint color bleeding
Apply in nice weather, don't let coating contact any liquid like water or other solvent before completely dry
No painting be carried out in rainy day outdoor
If above 85% humidity please stop painting
Temperature of substrate should be above 5¡ãc
Lower temperature might not dry or cause long time to dry
•air spray:nozzle orifice range: 1.5 to 2.5mm
Nozzle pressure range: 0.3 to 0.5mpa
•airless spray:nozzle orifice range: 0.4 to 0.5mm
Nozzle pressure range: 12 to 15mpa
•features:brush: use soft brush
Recommended finish: rsl series
Storage temperature: 5 to 30¡ãc in well ventilated warehouse
Stir thoroughly before painting
Don't use any steel or other metal stick to stir paint
