Dshhgp1-2021-60hz
2 hp grinder pump
1.Ideal for long discharge runs or high static heads
2.2 piece motor housing
3.Separate cord cap assembly
4.Internal capacitors - no control box req'd ductile iron impeller, recessed, clog-free dual silicon carbide seal - grit resistant stainless steel grinder assembly effectively macerates domestic sewage into a fine slurry
5.30 year proven design
1.1/2" solids handling
2.Heavy duty lip & mechanical seals in tandem
3.115 & 230 volts available
4.60hz
5.Durable cast iron motor housing
6.115 & 230 volt piggyback power plug and switch
Plug w/20' cord as standard
Arcing is eliminated. Connect the red battery clamp to the positive battery terminal. Connect the black
Clamp to the negative or ground to a rigid metallic surface on the engine. The connection should be 12 to 19 inches from the battery.
4.Hose:
Since the pump has a lower discharge pressure it is ., recommended that anoncolapsiable hose be used for maximum pumping capacity.
5.Hoisting & lowering:
Use the attached nylon line. Do not use the power cord ., for handling the unit.
6.Operation of unit:
Lower the unit into the liquid to be pumped(note: this unit is not to used to pump
Flamable liquids).Then turn on the switch.
Pump can be run for a few minutes(less than 5) without liquid. Do not run completely dry for any extended period(less than 5 min.).This will prevent.
7.Running time peroids:
The unit draws 20-25 amperes and can be operated for approximately 1 hr. On a fully charged 60 amp-hour battery and still be able to start the vehicle under normal conditions. Caution should be used when running times exceeds 25 !v 30 minutes without the engine running to recharge the battery. Also be mindful of cold temperatures which lowers battery
6 Concrete Mixer Concrete Pump Suppliers
Short on time? Let Concrete Mixer Concrete Pump sellers contact you.
