Single-head Automatic Seal Ring Making MachineApplication: The equipment is applied to make the seal rings of 18L / 20L chemical cans,Website:http://www.xinchengcanmaking.com, and paint buckets.This machine is used to fill the sealing strips of the chemical cans or paint buckets automatically, which breaks original manual operation. It really realizes unmanned operation.We adopt the EVA foaming technology, using EVA foaming strips instead of the traditional rubber strips. The cost of the traditional rubber strips is high, which needs 0.5-0.8 RMB per cap. However, EVA foaming strips are much cheaper, only need 0.06-0.07 RMB per cap. The EVA foaming strips are not only cheap, they also have better sealing effect. At the same time, they have the advantages of acid and alkali resistance and corrosion resistance. Parameters:Single-head  Automatic Seal Ring Making MachineWeight0.4TVoltageThree-phrase  380VSize mmlength*width*height1050*1050*1400Pressure4-6MPaProduction  Capacity16 sets/ minTotal Power1.5kw System ParametersCushion Angle50 degreesCushion Revolution0.3 revolution/sPulses/circle1000Reduction Ratio9 Advantages:The equipment can reduce workersâ?? workloads, and help workers improve work efficiency.The equipment is easily operated, and can control the length of the rubber strip accurately. Services:Ã? Provide the technical design and solutions;Ã? Designing and manufacturing of non-standard equipment;Ã? Professional technical training and guidance on site according to the contract;Ã? Tele-technical consulting and services;Ã? Other special technical service according to clientâ??s requirements. Faults & Methods for Single-head automatic seal ring making machine:Fault 1: The unreeling machine keeps spinning for a long time.Cause: It induces unreeling signal unsuccessfully.Method: On the premise of having material, please adjust the proximity switch to the center of the gravity wheel, till the light is on.Fault 2: The feeding cylinder doesnâ??t go forward.Cause: Its start- point or all parts of it induce the signal unsuccessfully.Methods: Please check the small cylinderâ??s induction which can screw down & lift up in the pushing part;Please check the induction of pushing cylinder;Please check if the photo-electricity switches of all work-pieces are on;Please check if the gas path is unobstructed.
