Addition cure Electronic Potting Silicone Rubber
1. Product Feature of Addition cure Electronic Potting Silicone Rubber
Electronic Potting Silicone Rubber is a kind of low viscosity, Inherent flame resistance, two components addition cured potting silicone with heat-conducting. It cures with both on room temperature and heated temperature. It has the feature of the higher temperature the faster of the curing time. It can be applied to electronic components for insulation, waterproofing, fixed and flame retardant. It mainly applied in electronic components surface with materials of PC(Poly-carbonate)ã?�PPã?�ABSã?�PVC, etc. and metal materials.
2. Typical Application of Addition cure Electronic Potting Silicone Rubber
HY-9055 electronic potting silicone rubber could be applied to
- high powered electronics,
- DC/DC module and circuit board which requires heat dissipation and high temperature resistance.
-It can be broadly used for LED screen, Wind Power Generator, PCB substrate, etc.
3. Technical Guidelines of of Addition cure Electronic Potting Silicone Rubber
a, Pls put part A and part B in separate container and stir evenly before mixing the two part together.
b, Mixing Ratio: part A: part B = 1:1
c, Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes.Then the mixture could be used for pouring.
4.Notes of Addition cure Electronic Potting Silicone Rubber
a.The following material may hinder the curing of HY-9055, So pls use after the test. When necessary, pls clean the application areas.
Organotin compound or Condensation silicone with organotin
Sulphur, sulfide and sulfur rubber materials.
Amine compounds as well as contains the amine materials.
Pewters solder flux
b. HY-9055 should be sealed storage.The mixture should be used up disposably to avoid causing waste.
c. HY-9055 belongs to non-dangerous goods, but keep away from mouth and eyes.
d. When it gets stratified after a period of storage, Please mix it evenly before using,which does not affect the performance.
PACKAGE
40Kg/pail as a set (Part A 20Kg + Part B 20Kg)
SHELF LIFE AND TRANSPORTATION
1. Twelve(12) months when stored at 24C in tightly closed original packages.
2. This kind of product is non-dangerous product, which could be transported as general chemicals.
3. Storage beyond the expired date doesnot necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.
-
Supplier: Remelted zinc ingots, pwg zinc ingots, zinc dross, zinc ash, zinc oxide, lead dross, magnesium ingots, all grades, silicon metal, lead ore/ concentrate, zinc concentrate/sulphide
Buyer: Zinc dross, zinc ash or skimming from hot dip galvanizing process, zinc fines, zinc die cast scraps, lead dross, brass and copper scraps
Supplier: 1. soya meal gmo & non gmo.
2. canadian wheat
3. canadian red lentil
4. canadian green peas.
5. red seats oil.
6. soya oil.
7. non gmo granular fine white sugar icumsa 45
8 urea fertilizer, sulphur
9. ethanol
10 . degummed soya crude oil, non gmo yellow corn, canadian premium quality all purpose white flour
11. canadian canola seed, canola oil, canola meal
all shipment able to proceed, under 100% lc at sight condition
