Power input Rated voltage 3-phase AC220V/AC230V/AC380V/AC400V/AC415V/AC440V/AC460V/AC480V
1-phase
AC220V/AC230V
Rated input current See Section 2.3 in user manual
Frequency 50Hz/60Hz, acceptable fluctuation range ¡¨¤5%
Allowable range of voltage Continuous voltage fluctuation ¡¨¤10%, short fluctuation -15%~+10%, i.e. 323V~528V;
Voltage out-of-balance rate <3%, distortion rate as per the requirements of IEC61800-2
Power output Standard applicable motor (kW) See Section 2.3 in user manual
Rated current (A) See Section 2.3 in user manual
Output voltage (V) 3-phase: 0~ rated input voltage, Bias < ¡¨¤3%
Output frequency (Hz) 0.00~ 600.00Hz; unit: 0.01Hz
Overload capacity 150% - 1min; 180% - 10s; 200% - 0.5s once per 10 minutes
Operation characteristics Control mode V/f control
Sensor-less vector control without PG 1
Sensor-less vector control without PG 2
Range of speed regulation 1:100 ( V/f control, sensor-less vector control without PG 1)
1:200 (sensor-less vector control without PG 2)
Speed accuracy ¡¨¤0.5% (V/f control)
¡¨¤0.2% (sensor-less vector control without PG 1 & 2)
Speed fluctuation ¡¨¤0.3% (sensor-less vector control without PG 1 & 2)
Torque response < 10ms (sensor-less vector control without PG 1 & 2)
Starting torque 0.5Hz: 180% (V/f control, sensor-less vector control without PG 1)
0.25Hz: 180% (sensor-less vector control without PG 2)
Basic functions Start frequency 0.00~ 600.00Hz
Acceleration/deceleration time 0.00~60000s
Carrier frequency 0.7kHz~16kHz
Frequency command source Digital command + operating panel ¡Ä/¡Å
Digital command + terminal UP/DOWN
Communication
Analog command (AI1/AI2/EAI)
Terminal pulse command
Motor Started method Started from starting frequency
DC braking and then started
Speed search then started smoothly
Motor Stopped method Ramp to stop
Coast to stop
Ramp stop + DC brake
Basic functions Dynamic brake capacity Brake unit action voltage: 650V~750V; service time: 0.0~100.0s; brake unit for GK600-4T45G/55L or below could be internally mounted
DC brake capacity DC brake start frequency: 0.00~600.00Hz
DC brake current: 0.0~100.0%
DC brake time: 0.0~30.00s
Input terminals Six digital input terminals (can be extended to 7), one of which can be used for high-speed pulse input. Compatible with active open collectors NPN, PNP and dry contact input
Two analog input terminals, one of which is voltage/current programmable, and the other is voltage only (can be extended to 3; extension terminal is voltage/current programmable)
Output terminal One high-speed pulse output terminal, 0~50kHz square wave signal output; can output signals such as setting frequency and output frequency. etc
One digital output terminal
One relay output terminal (can be extended to 2)
One analog output terminal (can be extended to 2), voltage/current output optional; can output signals such as setting frequency and output frequency, etc
Characteristics Parameter copy, parameter backup, common DC bus, free switching between two motors¡¡¥ parameters, flexible function code displayed & hidden, various main & auxiliary command and switchover, speed searching, a variety of acceleration/deceleration curves optional, automatic correction of analog value, mechanical brake control, 16-step speed control programmable (2-step speed supports flexible frequency command), swing frequency control programmable, fixed-length control, counting function, three faults recorded, over excitation braking, over voltage stall prevention, under voltage stall prevention, restart upon power off, hopping frequency, frequency binding, free switching between four sections of acceleration/deceleration time, motor thermal protection, flexible fan control, process PID control, simple PLC, flexible multi-functional key setting, droop control, parameter identification, weak magnetic control, high-precision torque restraint, V/f separated control
Protection function Refer to Chapter VII - Fault Diagnosis and Abnormity Handling
Environment Place of operation Indoors, no direct sunlight, free from dust, corrosive gases, flammable gases, oil mist, water vapor, water drip or salt content etc.
Altitude 0~2000m
Derating is required where altitude is more than 1,000m; each increase of 100m in height corresponds to a decrease in rated output current by 1%
Ambient temperature -10¡ãC~50¡ãC
Humidity 5~95%, condensation not allowed
Vibration Less than 5.9m/s2 (0.6g)
Storage temperature -40¡ãC~+70¡ãC
Others
Efficiency Rated power
7.5kW and below: ¡Y93%
11~ 45kW: ¡Y 95% 55kW and higher: ¡Y98%
Installation mode Wall-mounted
Protection level IP20
Cooling mode Forced air cooling
Country of Origin: China (Mainland) Guangdong
Brand: GTAKE
Model: as type
Output power: other
0.4KW-800KW
Output type: Triple
Size: as model
Weight: as model
Input voltage :208V/220V/230V/380V/400V/415V/440V/460V/480V
Output: 0-rated input voltage
Type: AC/AC, or DC/AC inverters
Output frequency: 0.00-600.00Hz
Output current: as model
Input terminals: DI-7(HDI-1), AI-3 0~10V, or 0-20mA
Output terminals: DO-2(HDO-1), RO-2, AO-2
Certificate: CE, GOST
Applying motor: Asynchronous motor and synchronous motor
Cooling: Air cooling
IP grade: IP20
Input voltage: AC, or DC
Frequency command source:Keypad, terminals, communication
Communication: Modbus, Profibus-DP, CANopen, CAN
Control technique: V/f, SVC1, SVC2
Place of Origin:Guangdong, China
Brand Name:rawsuns
Model Number:RDD2800 motor and inverter
Type:Synchronous Motor
Phase:three-phase
Certification:ce
Protect Feature:IP67
AC Voltage:336/540/576VDC
Efficiency:90%
rated power:100kw
peak power:200kw
rated torque:1200Nm
peak torque:2800Nm
max speed:2600rpm
Place of Origin:Guangdong, China
Brand Name:Rawsun
Model Number:RMHD2400
Type:Synchronous Motor
Phase:three-phase
Certification:ce
Protect Feature:IP67
Cooling type:water
Motor Type:PMSM
Motor Rated (Kw):100/90
Motor Peak (Kw):180/150
Rated Torque (Nm):260/950
Peak Torque (Nm):450/2100
Transmission ratio:Reduction gearbox
Place of Origin:Guangdong, China
Brand Name:Rawsuns
Model Number:READ40000Z
Type:Synchronous Motor
Frequency:200Hz
Phase:three-phase
Certification:CCC, ce
Protect Feature:waterproof
AC Voltage:208-230 / 240 V
Efficiency:IE 2
Rated Voltage:125kw
Peak Voltage:180kw
Rated Torque:350 Nm
Peak Torque:750 Nm
Ratio:53/17
Max Speed:10000 rpm
Warranty:
12 months
Model Number:
RAD16000
Type:
Synchronous Motor
Phase:
Three-phase
Protect Feature:
Waterproof
AC Voltage:
576VDC
Efficiency:
-
name:
NEW 16360Nm 300kw electric ac motor ev drive car kit
Motor Type:
PMSM
motor rated:
180kw
motor peak:
300kw
rated torque:
850Nm
peak torque:
1950Nm
peak speed:
3500rpm
Transmission ratio:
4 Gear AMT
Protection level:
IP67
Cooling method:
Liquid Cooling
