Model Number:
Portable Air Conditioner ((WT-F26 gray)
Power Type: DC
Use: Room
Condition: New
After-sales Service Provided: None
Warranty:1 year
Type: PORTABLE
Certification:CB, ce
Cooling/Heating:Cooling Only
Application:Car, Commercial, Garage, Hotel, Household, Outdoor, RV
Power Source:Electric, usb
Remote Control: Yes
App-Controlled: Yes
* PURPOSE
customers using FBC boilers (Particularly underbed feed FBC boilers) for the protection of inbed coils against erosion potential by applying highly abrasive resistant refractory on inbed coils above fuel feed system.
BACKGROUND
* Two of such actions are providing special alloy studs on inbed coils and applying highly abrasive resistant refractory on the outer bottom loops of inbed Coils which are above the fuel feed nozzles.
* GANESHAS has taken number of approaches to identify the key factors affecting erosion rates with an objective to enhance the life of inbed tubes as well as implementing the corrective action to reduce the erosion rates.
Phosphate coatings are often used to protect steel parts against rusting and other types of corrosion
* Erosion of inbed coils in fluid bed combustor is unavoidable phenomenon however the rate of metal wastage and thus the life of tubes depends on various factors like ash & fuel properties, design of Combustor / feeding system, flue gas velocities operating conditions etc. It has been also observed that maximum erosion prone inbed coils are those which come above fuel feed nozzles and an area of approximately 1 to 1.5 mts around fuel feed systems are badly affected.
APPLICATION
Phoscast-90 XR can be applied by ramming with wooden mallet having adequately large head @" dia x 5" length x 10â?? Jong handle). The desired lining or repair thickness is built up in several courses while ramming the mass to uniform thickness. Phoscast refractory should never be trawled to obtain smooth surface; ramming only should finish surface. Any excess mass is to be sliced off with trowel edge and then finished by ramming again for bed coil. Tube application of AFBC boiler, the material pasty mass should be finger pressed into the studs of the tube with maximum force. Finish should be given by pressing the hand palm against material applied, using surgical type thin rubber hand gloves.
Bucket elevator is suitable for lifting from low to high. After the supplied materials are put into the hopper through the vibrating table, the machine will automatically operate continuously and transport upward. The conveying speed can be adjusted according to the conveying capacity, and the lifting height can be selected as needed. The hopper is designed and manufactured by ourselves. PP non-toxic hopper makes this bucket elevator more widely used. All dimensions are designed and manufactured according to the actual needs. It is designed for supporting vertical packaging machine and computer metering machine. It is suitable for the lifting and feeding of food, medicine, chemical industrial products, screws, nuts and other products, The automatic stop and start of the machine can be controlled through the signal recognition of the packaging machine.
TDTGW low speed bucket elevator is a new design products made with foreigner advanced imported technology. It is used for elevating the grain and oil, food materials, animal feed materials or chemistry materials. It designs with low speed elevation to avoid broken rice, and for the bucket belts can be auto-tightening. For the base easy to clean materials and used special feeding channel which reduces breakage.
Featuers:
1).low working speed, can elevator the materials with high capacity.
2).can take various kinds of materials like wheat or corn or rice or beans.
3).low power consumption, high working efficiency.
