Multi-functioncal vw mobile street food cart has its unique advantage,
It allows small entrepreneurs to solve the two difficult problems of location difficulties and rent expensive,the mobile shop decoration costs low,to reduce the responsibility of the entreprencurs,
The most attractive is that it can move at any time,where the customer,where the dining car goes,to solve a series of problems later.
Serin otomotiv ltd is an independent wholesale distribution business (with our trade mark brakingtech) situated in izmir, turkey. We are the specialists in the procurement and supply of repair kits and spare parts of brake caliper for commercials vehicles (scania, man, daf, renault trucks, volvo trucks and mercedes, trucks, buses, trailers)
Multi-functioncal vw mobile street food cart has its unique advantage,
It allows small entrepreneurs to solve the two difficult problems of location difficulties and rent expensive,the mobile shop decoration costs low,to reduce the responsibility of the entreprencurs,
The most attractive is that it can move at any timewhere the customer,where the dining car goesâ??,to solve a series of problems later.
Based on the serial number 10KA0976, your equipment is a SkyTrak 10000M ATLAS telehandler, also known as the All-Terrain Lifter Army System (ATLAS) with a 10,000 lb capacity. Here are the key specifications:
Lifting Capacity: 10,000 lbs (4,536 kg)
Maximum Lift Height: Approximately 27.5 ft (8.38 m) with the 10,000 lb carriage
Maximum Reach: Approximately 24 ft (7.4 m)
Dimensions:
Height: 102 inches (259 cm)
Width: 100 inches (254 cm)
Turning Radius: 13.5 ft (4.1 m)
Frame Tilt: 9 degrees each way
Hydraulic Reservoir Capacity: 55.6 gallons (214 liters)
Fuel Tank Capacity: 44 gallons (167 liters)
Boom: Telescopic 3-stage
Steering Modes: 2-wheel, 4-wheel, and crab steering
Fording Depth: Up to 36 inches (91 cm)
Transportability: Air transportable in C-130, C-141, C-5A, and C-17 aircraft
We are glad to propose 500 MT of stain less steel mill scale.
Mill scale is formed on the outer surfaces during by the hot rolling lamination of stainless-steel products.
At a visual inspection the material is a hard brittle sand and is mainly composed of iron oxides, mostly ferric, and is bluish black in colour, but it also contains considerable alloying elements such as chromium and nickel.
The recovery ratio after melting in furnace for the most valuable alloy elements is:
- Ni: 3.5 - 4.5%
- Cr: 6-8%
From the chemical and physical analysis performed on the scrap, and according to the European environmental rules, the material has been classified as a special non dangerous waste, listed in green list. In particular the mill scale can be classified as follows:
Waste code: 10 02 10
The material is stored on cemented flooring, and it can be loaded loose in tipper trucks or containers.
Chemical analysis of the material is available on request.
