Specifications:
High Tensile Steel Wire as per the following specs
Bright Plain High Tensile Steel Wire of 7mm Diameter QTY 250 Metric Tons
1) Steel required must be bright plain - high tensile steel wire 7mm diameter and will be used in manufacturing prestressed concrete poles for medium voltage networks.
2) The steel should conform in all respects with the requirements of the latest edition of BS. 5896 or Chinese specifications [prestressed wire 7.00-1570-WLR-P-GB/T 5223/2002] or equivalent.
3) The nominal tensile strength of the steel should be (1570 N/mm2).
4) The steel should be of “Low relaxation “quality, and the wire is pre-straightened and will run out straight form the coil when used at site.
5) No joint is allowed in the wire which should be one piece in the coil.
6) Steel should be supplied in large diameter coils of (1.8 -2.4) m.
7) The weight of Each coil should be approximately 1000 kgs.
8) Good attention should be paid to the packing of each coil to ensure good protection to the steel during loading, shipping, unloading, transportation, and storing at the site of the purchaser. For that, every coil should be tightly wrapped by proper and secure seaworthy packing.
9) Each coil should have a separate label made of steel sheet with a reasonable size. This label should contain the following information: will be given upon production
10) The price should be valid for at least Two Month and must be based on steel NET weight.
Specifications:
Quantity : 500 MT Per Month
1. 0.79 mm thick and 194 mm width weight is 1.6to1.8 ton. need 100 MT PER MONTH
2 0.64mm thick and 194 width,1.6to1.8 tos weight. need 50 MT PER MONTH
3. 0.89mm thick,194 width,1.6 to1.8 tons weight. need 100MT PER MONTH
4. 1.27mm thick and 131mm width,1.6to1.8mm weight need 150 MT PER MONTH
5. 1.27 thick 164 mm width,1.6to1.8 ton weight. need 100 MT PER MONTH'
Specifications:
1. SK5M HOOP (hardened and tempered) material of thickness 0.4mmx74 mm. Colour Blue. ( In coil form)/or C80 also will be considered.
2. Require a width of 74,2 mm with the tolerance of +/-0.2 mm.
3. Hardness mentioned in the attached table.
4. Surface finish must be smooth, preferred if blue material is available.
5. No rust or scales permitted.
Quantity Required: 2 Tons Of Each Material Per Month.
